Orchid SoundWave 32, User Manual

Page: 24 / 75

Section 1: Installing SoundWave 32
22 SoundWave 32 User's Manual
drive. This information, however, will outline the
basic steps of installing an internal CD-ROM drive.
Your CD-ROM drive kit contains the necessary hard-
ware, audio and interface cables in addition to the
CD-ROM drivers you need to work with the CD-
ROM drive.
To Install an Internal CD-ROM Drive:
1. Make sure your system is turned off and unplug
all power cords.
2. Check your CD-ROM drive’s address settings.
The address settings are configured at the factory
with default settings. Refer to your CD-ROM
drive installation manual for altering the settings
or for troubleshooting information.
3. Install the drive into an available drive bay. Slide
the drive in and screw it to the drive frame.
4. Attach the power, interface connector cable and
audio cable to the CD-ROM drive. Refer to your
CD-ROM Drive’s Installation manual for these
steps.
5. Connect the interface connector cable to the
Mitsumi (J1) or Sony (J2) interface connector on
the SoundWave 32.
6. Connect the audio cable to the CD-ROM audio
connector on the SoundWave 32.
7. At this point, carefully hold the SoundWave 32
by its top edges and lower it into its expansion
slot. Ensure that the SoundWave 32 seats firmly
into the slot, and that it aligns properly with the
computer's backplane. Be very careful that the
cables attached to the card do not get tangled or
pinched.
8. Secure the SoundWave 32 in place by fastening
its metal bracket to the computer backplane with
the screws that were removed.
For
installation
of your
CD-ROM
drive, you
will need a
Phillips-head
screwdriver
and a
flathead
screwdriver.