Orchid SoundWave 32, User Manual

Page: 25 / 75

Section 1: Installing SoundWave 32
SoundWave 32 User's Manual 23
9. If you are connecting a microphone and external
speakers to the SoundWave 32, see Figure 1.5 for
connection locations.
10. Replace the cover of the computer along with the
previously removed cables and power cords.
11. When all of these steps are complete, your CD-
ROM drive should be connected to your PC’s
power supply and to the SoundWave 32. For
instructions on operating your CD-ROM drive,
refer to your CD-ROM drive installation manual.
12. Install the device drivers that came with your
CD-ROM drive. For example, if you are using a
Sony drive, use the Sony CD-ROM drivers. If
you are using a Mitsumi drive, use the Mitsumi
CD-ROM drivers.
To access the CD-ROM drive, the MSCDEX.EXE
driver must be added to your AUTOEXEC.BAT
file. Refer to Section 2: Device Drivers for infor-
mation on installing the MSCDEX.EXE driver,
and for details on the device driver parameters.
NOTE: Refer to your CD-ROM drive documentation
for installing appropriate device driver(s) and pa-
rameters for your drive. For example, the following
lines must be added to your CONFIG.SYS file:
For the Sony drive:
Device=C:\SW32\SWCD.SYS /i:9 /a:360
Device=C:\Sony\SLCD.SYS /d:Sony-000 /b:340 /m:p /v /c
For the Mitsumi drive:
Device=C:\SW32\SWCD.SYS /i:9 /a:360
Device=C:\Dev\MTMCDS.SYS /d:MSCD001 /p:360 /a:0
Guidelines
Use the following guidelines to configure your CD-
ROM device driver:
Be sure to
plug in all
cables
before
powering up
your PC.
The
SWCD.SYS
device driver
must be
loaded
before any
other CD-
ROM device
driver. Refer
to Section 2.