34 |
orbitalum tools
GmbH, D-78224 Singen, www.orbitalum.com, Tel. +49 (0) 77 31 792-0
(01.2012) OM_BA_ORBIMAT_CA_01_EN
OPERATION
ORBIMAT CA
| Operating instructions
Limit values specified in the program are taken into account.
Fig. 18 Display during runing welding process
Progress of process
: Bar graph with specifications of process progress (in %) for the respective current sector
Correction factor:
Percent value by which the current in the current process was changed in comparison to the
saved procedure
Parameters Diameter to Wire LP Speed
: Display of the process parameter of the procedure. The values can be changed
during the welding process. The changes are saved to the current welding process by pressing the rotary knob (key-
board: ENTER). The changes are not yet saved in the procedure. Fields with a gray background cannot be edited.
Graphic
: Display of the weld sequence. After starting up, a pointer pointing to the inner yellow dot appears during gas
pre purge. After the gas pre purge, pool formation occurs (the time after ignition during which no rotational movements
are occurring for buildup of the weld pool). In the individual sectors, the respective current sector is highlighted in
white, and the accompanying red indicator indicates the current electrode position. The current sector number and
current position (in angular degrees) appear in the bottom section of the graphic.
Info field
: The following information appears in the info field (below the graphic): Name of the folder in which the proce-
dure is saved, name of the running procedure, current measurement values for water flow (in L/min), water temperature
and inverter temperature (in °C); current mains voltage (in V).
Warning messages and error messages appear in the "Warning" field.
The info field only appears during a running welding process.
Other:
The following information appears on the two bottom lines: Help texts for operation with the rotary knob; on the
right, information on the activated printer and the memory card (diskette symbol). When the printer is activated (e.g.
log printing after welding) or the card is activated (procedure being loaded), the symbols are highlighted in red.
Softkeys:
The current assignment of the softkeys appears at the bottom edge of the display. During the welding pro-
cess, only softkeys 1 and 2 ("Stop" and "Final slope") are active.
Ending the welding process
The following steps are carried out automatically at the end of the welding process:
•
Current is automatically sloped off to the programmed final current.
•
The arc is extinguished.
•
Gas flow and water cooling are deactivated after the programmed time expires.
•
Machine switches to ready-to-start condition.
8.2.4
Interrupting the welding process
Switching off entire system
X
XXSwitch off machine at the main switch.
– or –
Summary of Contents for ORBIMAT 165 CA
Page 78: ...orbitalum tools gmbh Notizen Notes ...
Page 79: ......