Oracle Fabric Interconnect F1-15, User Manual

Page: 127 / 176

Replace the Fabric Interconnect F1-4 QDR Fabric Board
QDR Fabric Board into a Fabric Interconnect F1-4,” on page 127 . The Fabric
Board is properly seated when it and its handles lie flush against the chassis.
FIGURE 82
Seating a QDR Fabric Board into a Fabric Interconnect F1-4
Caution -
Do not force the levers. They should glide easily when properly aligned. If you feel
uneven resistance or the release levers do not move easily, gently swing the levers away from
each other, partially remove the Fabric Board, and attempt Step 10 through Step 12 in “Upgrade
a Fabric Interconnect F1-4 to a QDR Fabric Board” on page 134 while paying attention to
how the release levers contact the edge of the chassis.
11. When the release levers have correctly locked the QDR Fabric Board into the
chassis, use the screwdriver to secure the captive screws in the release levers
(2).
Caution - When tightening screws, make sure to tighten them to lightly snug. Do not
overtighten screws or they can break.
12. Reconnect the Fabric Interconnect to facility power, then power on the Fabric
Interconnect, and allow it to completely boot up.
The Fabric Board will boot, and when the board completes is bootup and passes to runtime, the
Power LED will glow. The Power LED does not glow until the Fabric Board is in runtime.
Performing Service Tasks 127