Oracle Fabric Interconnect F1-15, User Manual

Page: 91 / 176

Connect Power for the Fabric Interconnect F1-4
1. Get the two cable tie wraps from the accessory kit. Notice that one side is
smooth and one side has teeth.
Note -
You will find it helpful to orient the cable tie as follows: - the smooth side is facing the
chassis and the ribbed side is facing you. - the release tab is at the top of the tie wrap. Orienting
the cable tie this way facilitates locking and releasing the power cable (if needed) when the
cable tie is in use.
2.
Insert the cable tie through the top slot of the anchor first, then the bottom
slot. Figure 23, “Power Cord Anchor,” on page 47 shows the location of
the anchors. Make sure that the cable tie is threaded through both the top and
bottom slots.
3.
Plug the power cord into the power socket on the Fabric Interconnect F1-4, but
do not connect the power cord to facility power yet.
4.
Hold the power cable taut against the anchor, and pull the tie wrap tight to hold
the power cord in place. There should be little or no slack in the cable tie due to
considerations with the power cords.
Installing the Fabric Interconnect 91