Oracle Fabric Interconnect F1-15, User Manual

Page: 118 / 176

Replace the Fabric Interconnect F1-15 QDR Fabric Board
FIGURE 74
Securing the Fabric Interconnect F1-4's Fabric Board
4.
When both Fabric Board handles are in contact with the threaded standoff on the
faceplate, use the screwdriver to sink the captive screws (2), which tighten into
the threaded standoffs.
Replace the Fabric Interconnect F1-15 QDR Fabric
Board
The Fabric Interconnect F1-15 Fabric Board is on the rear of the chassis. To replace the Fabric
Interconnect F1-4 Fabric Board, you will need a #2 Phillips-head screwdriver.
Note -
This procedure is applicable to replacing a QDR Fabric Board with another QDR
Fabric Board. If you are upgrading from a non-QDR Fabric Board to a QDR Fabric Board,
use the procedure documented in “Upgrading a DDR Fabric Board to a QDR Fabric
Board” on page 128 .
To replace the Fabric Interconnect F1-15 QDR Fabric Board, follow this procedure:
1. Power down the Fabric Interconnect.
118 Oracle Fabric Interconnect Hardware User's Guide • July 2016