Oracle Fabric Interconnect F1-15, User Manual

Page: 123 / 176

Replace the Fabric Interconnect F1-4 QDR Fabric Board
12.
Reconnect the Fabric Interconnect to facility power, then power on the Fabric
Interconnect, and allow it to completely boot up.
The Fabric Board will boot, and when the board completes is bootup and passes to runtime, the
Power LED will glow. The Power LED does not glow until the Fabric Board is in runtime.
Replace the Fabric Interconnect F1-4 QDR Fabric
Board
The Fabric Interconnect F1-4 Fabric Board is on the rear of the chassis. To replace the Fabric
Interconnect F1-4 QDR Fabric Board, you will need a #2 Phillips-head screwdriver.
Note -
This procedure is applicable to replacing a QDR Fabric Board with another QDR
Fabric Board. If you are upgrading from a non-QDR Fabric Board to a QDR Fabric Board,
use the procedure documented in “Upgrading a DDR Fabric Board to a QDR Fabric
Board” on page 128 .
To replace the Fabric Interconnect F1-4 QDR Fabric Board, follow this procedure:
1.
Power down the Fabric Interconnect.
2.
Disconnect all cables attached to the server ports, as well as any other cables
that could interfere with the Fabric Board's removal.
3.
Using a screwdriver, loosen the captive screws in the release levers by turning
them counterclockwise (1). Figure 79, “Unlocking the Fabric Interconnect F1-4's
Fabric Board,” on page 124 .
Performing Service Tasks 123