Oracle Fabric Interconnect F1-15, User Manual

Page: 55 / 176

Attach the Right Angle Bracket in a 27-Inch Sun/Oracle Rack
slots in the rack-depth rails and tighten them into the screw holes in the right
angle brackets (2).
Note -
You might find it helpful to tighten the screws to finger tightness or just less. By doing
so, you allow the Fabric Interconnect to slide forward and backward in the rack-depth rail's
slots, and as a result, you can make minor adjustments to the Fabric Interconnect's depth in the
rack (if needed).
4. Install the Cable Management Assembly (CMA) as documented in “Installing the
Cable Management Assembly” on page 37 .
The same CMA is supported for both the Oracle Fabric Interconnect F1-15 and Oracle Fabric
Interconnect F1-4, so use the same procedure. Where illustrations show the Oracle Fabric
Interconnect F1-15, you will substitute the Oracle Fabric Interconnect F1-4.
5. Install the I/O modules as documented in “Installing an I/O
Module” on page 69 .
6. Cable the Fabric Interconnect F1-4 as documented in “Connecting the Fabric
Interconnect to Other Equipment” on page 77 .
7. When the Fabric Interconnect F1-4 is installed on the rack and cabled to the
other equipment, you will plug in the power cords and anchor the power cables
in place as documented in “AC Power” on page 89 .
Attach the Right Angle Bracket in a 27-Inch Sun/
Oracle Rack
1.
Align the 27-inch angle bracket for the Oracle Fabric Interconnect F1-4 so that it
is outside of the side panels.
2.
From inside the side panels, insert the M3.5 flat-head screws through the slots in
the side panel and into the angle bracket's screw holes.
See Figure 28, “Aligning the Angle Brackets and Inserting the Screws,” on page 56 . Each
angle bracket requires 3 screws.
Installing the Fabric Interconnect 55