Oracle Fabric Interconnect F1-15, User Manual

Page: 138 / 176

Upgrade a Fabric Interconnect F1-4 to a QDR Fabric Board
12.
When the notches and guides are properly positioned, press the Fabric Board's
handles inward to seat the Fabric Board (1) as shown in Figure 90, “Seating a
QDR Fabric Board into a Fabric Interconnect F1-4,” on page 138 . The Fabric
Board is properly seated when it and its handles lie flush against the chassis.
FIGURE 90
Seating a QDR Fabric Board into a Fabric Interconnect F1-4
Caution -
Do not force the levers. They should glide easily when properly aligned. If you
feel uneven resistance or the release levers do not move easily, gently swing the levers away
from each other, partially remove the Fabric Board, and attempt Step 10 through Step 12 while
paying attention to how the release levers contact the edge of the chassis.
13. When the release levers have correctly locked the QDR Fabric Board into the
chassis, use the screwdriver to secure the captive screws in the release levers
(2).
Caution - When tightening screws, make sure to tighten them to lightly snug. Do not
overtighten screws or they can break.
14. Reconnect the Fabric Interconnect to facility power, then power on the Fabric
Interconnect, and allow it to completely boot up.
138 Oracle Fabric Interconnect Hardware User's Guide • July 2016