![background image](http://html1.mh-extra.com/html/omron/v690-series/v690-series_user-manual_741403092.webp)
5-9 Antenna Setting Command
5-36
5-9-2 Communication Range Mode and Radio Wave Channel Selection
Selects a communication range mode and radio wave channel of an antenna. A communication range mode can be changed by selecting
the communication range mode. Frequency is changed by selecting the radio wave channel and interference between antennas and
interference caused by any other radio equipment are prevented.
<Command Format> * A figure below shows the number of characters.
<Response Format> * A figure below shows the number of characters.
DA
Operation mode
Destination (antenna) station number. "00" to "31". This
can be modified in "5-9-8 Station Number Setting".
Initial value "00"
Setting mode
"99"
SA
Source (host device) station number. "80" to "89". If only one host device is used, specify "80".
Command code
A4: Selects a communication range mode.
A5: Selects a radio wave channel.
Set value
For the command A4
L: Communication range 2 m mode
H: Communication range 5 m mode
Initial value of com-
munication range
L (2 m mode)
For the command A5
"0" to "9": Divides the frequency range 2437.5 to 2462.5 MHz into ten.
Initial value of radio
wave channel
Channel 5 (A value of
center)
DA
Destination (host device) station number. * In the command format, the destination is an
antenna.
SA
Source (antenna) station number.
Termination code
Fixed to "00".
Command
code
(BCC)
* It can be specified whether BCC is enabled or disabled.
Set value
Command
code
Termination
code
(BCC)
* It can be specified whether BCC is enabled or disabled.