![background image](http://html1.mh-extra.com/html/omron/v690-series/v690-series_user-manual_741403098.webp)
5-9 Antenna Setting Command
5-42
5-9-8 Station Number Setting
Specifies a station number as a radio station for an antenna. To enable this setting, you must issue a command and then issue the reset
command (Section 5-8-2) or reset the power supply.
<Command Format> * A figure below shows the number of characters.
<Response Format> * A figure below shows the number of characters.
DA
Operation mode
Destination (antenna) station number. "00" to "31".
Initial value "00"
Setting mode
"99"
SA
Source (host device) station number. "80" to "89". If only one host device is used, specify "80".
Command code
H6
New station num-
ber
"00" to "31"
DA
Destination (host device) station number. * In the command format, the destination is an
antenna.
SA
Source (antenna) station number.
Termination code
Fixed to "00".
Command
code
New sta-
tion num-
ber
(BCC)
* It can be specified whether BCC is enabled or disabled.
Command
code
Termination
code
(BCC)
* It can be specified whether BCC is enabled or disabled.