![background image](http://html1.mh-extra.com/html/omron/v690-series/v690-series_user-manual_741403097.webp)
5-9 Antenna Setting Command
5-41
5-9-7 Host Communication Condition Setting
Specifies the conditions of communication between a host device and antenna. To enable this setting, you must issue a command and
then issue the reset command (Section 5-8-2) or reset the power supply.
<Command Format> * A figure below shows the number of characters.
<Set Character String> Specify all together as shown below.
<Response Format> * A figure below shows the number of characters.
DA
Operation mode
Destination (antenna) station number. "00" to "31". This
can be modified in "5-9-8 Station Number Setting".
Initial value "00"
Setting mode
"99"
SA
Source (host device) station number. "80" to "89". If only one host device is used, specify "80".
Command code
H5
Communication
condition data
As described below.
Parameter Name
Byte
Length
Set Value
Meaning
Initial value
Communication condition in the setting mode
Transmission speed
1
1
2
3
4
5
6
4.8 kbps
9.6 kbps
19.2 kbps
38.4 kbps
57.6 kbps
115.2 kbps
"2" = 9.6 kbps
Data length
1
7
8
7 bits
8 bits
"7" = 7 bits
Parity
1
E
O
N
Even
Odd
Nil
"E" = Even
Stop bit
1
1
2
1 bit
2 bits
"2" = 2 bits
Communication mode
1
0
Fixed
"0"
BCC enabled/dis-
abled
1
0
1
BCC disabled
BCC enabled
"0" = BCC disabled
DA
Destination (host device) station number. * In the command format, the destination is an
antenna.
SA
Source (antenna) station number.
Termination code
Fixed to "00".
Correct Usage
If the data length is set to 7 bites, alphanumerical character only can be used.
Command
code
(BCC)
* It can be specified whether BCC is enabled or disabled.
Communication
conditions
Command
code
Termination
code
(BCC)
* It can be specified whether BCC is enabled or disabled.