Omron MicroHAWK, Integration Manual

Page: 84 / 378

4-4
MicroHAWK Engine Integration Guide
Network Interfaces
Network Interfaces
The MicroHAWK Engine supports network connectivity over three possible interfaces:
USB1, USB2, and Ethernet. Interface configuration is controlled by system parameters.
All interfaces are enabled by default.
Note that only one of the two USB interfaces can be used at a time, but it is possible to
connect Ethernet and one of the USB interfaces concurrently. The system automatically
detects which USB interface is connected.
If multiple interfaces are active at the same time, the system selects the Ethernet interface
as the primary network communication port as it offers the best performance.
Serial Interface
The MicroHAWK Engine supports serial communications via a UART. By default, the
sys
tem command port is mapped to this device. This connection supports a wide range
of serial parameters. The default settings are 115,200 baud, no parity, eight data bits,
one stop bit, and no flow control.