Omron MicroHAWK, Integration Manual

Page: 186 / 378

7-38
MicroHAWK Engine Integration Guide
Composite
Composite
When set to Enabled or Required , will decode the 2D composite component of a linear
symbol. The linear symbol can be DataBar-14, DataBar Expanded, DataBar Limited,
EAN-128, UPC-A, EAN-13, EAN-8, and UPC-E.
Enabled
If Composite is set to Enabled , the reader will decode both the 2D composite and linear
components. However, if the 2D composite component is not decoded, the linear data will
be sent by itself at the end of the read cycle.
Required
If set to Required , the reader must decode both components, or a No-Read will occur.
Separator Status (Composite)
Separator Character (Composite)
Note: The Separator Character will be the same as the character defined in the Multisymbol
Separator field of the <K222> command.
Usage: Allows reading by both linear and 2D readers.
Definition: Combines 2D and linear width-modulated symbology on the same symbol
where different messages can be read by each reader type.
Serial Cmd: < K453, mode, separator status,separator >
Default: Disabled
Options: 0 = Disabled 1 = Enabled 2 = Required
Usage: Allows the user to distinguish between the main and Supplemental symbols.
Definition: Separates the linear and the composite component.
Serial Cmd: < K453, mode, separator status ,separator >
Default: Disabled
Options: 0 = Disabled 1 = Enabled
Usage: As required by the application.
Definition: Allows the user to change the separator character from a comma to a new
character.
Serial Cmd: < K453, mode,separator status, separator >
Default: , (comma)
Options: Any ASCII character.