Olympus 38DL PLUS, User Manual

Page: 205 / 318

DMTA-10004-01EN, Rev. D, November 2016
Using the Datalogger 193
You can also quickly and easily create a note table on a computer using the GageView
interface program. Refer to the
GageView Interface Program — User’s Manual (P/N:
910-259-EN [U8778347]) for details.
To create or edit notes
1. Open the file in which you want to create or edit the notes (see “Opening a File”
on page 184).
2. Press [2nd F] , [ID#] (NOTE) .
3. In the FILE NOTES screen:
a) Select the letter code for the note that you wish to create or edit.
b) Press the [

] key to enter the edit mode.
c) Create or edit the note text.
d) Repeat steps 3. a to 3. c to create or edit other notes.
e) Select SAVE to save the note list to the file.
If there are any previous notes, the FILE NOTES screen may show these notes.
11.4.2 Associating a Note to an ID or to a Range of IDs
You can associate up to four notes to each measurement ID within a file. You can also
select to use up to four notes and save them to a range of IDs in a file. Notes can be
saved to an ID with or without a thickness reading. Notes can be added to an ID or a
range of IDs without overwriting the stored thickness readings.
To associate a note to an ID or to a range of IDs
1. From the measurement screen, press [2nd F] , [ID#] (NOTE) .
2. In the FILE NOTES screen (see Figure 11-24 on page 194):
a) Select the letter code for the note that you wish to associate.
NOTE
NOTE