Oki OKIPAGE 12i Series, Service Handbook

Page: 201 / 226

F - 12
3.3.2 TQSB-2 PCB
(1) Remove the pulse motor (see 3.3.1).
(2) Remove the connector O from the TQSB-2 PCB P .
(3) Remove the screw Q and remove the TQSB-2 PCB P .
Note : Refer to Detall A in the previous page.
3.3.3 Hopping Roller Shaft Assy and One-way Clutch Gear
(1) Follow up to step (3) of 3.3.1 and remove the hopping frame assy.
(2) Remove the screw
1
and remove the earth plate
2
. Remove the sensor lever
7
and
remove the ground plate
6
. Remove the gear
3
and remove the metal bush
5
and hopping
roller shaft assy
4
.
(3) Remove the E-ring
A
and remove the one-way clutch gear
B
on the right side of the feed
roller
0
.
Note : The metal bush C
also comes off. Be careful not to lose it.
4
1
2
3
5
A
B
C
0
9
8
6
7