NovoPort® IV
59
7.
Once the garage door is at the desired end position CLOSE, press the
programming button (PROG button) (D). The display shows “0”.
8.
Continue with the force learning cycle.
4.9.6
Force learning cycle
Fig. 4-12
Force learning cycle
1.
Press the OPEN button (B) or use the set hand transmitter. The garage door
moves from the end position CLOSE to the end position OPEN and stops
briefly. Afterwards, the door automatically moves to the upper stop and then
back to the end position OPEN.
2.
Press the OPEN button (B) again or use the set hand transmitter. The garage
door moves from the end position OPEN to the end position CLOSE. After
approximately 2 seconds, the “0” on the display disappears.
Crush and impact hazard at the garage door!
During the force learning cycle, the operator automatically learns the
normal mechanical force required to open and close the garage door.
Force limits are deactivated until the conclusion of the learning cycle.
The door movement will
not
be stopped by an obstruction!
•
Keep a sufficient distance from the entire path of motion of the
garage door!
NOTICE
•
During the force learning cycle the display shows “0”. Do not
interrupt this procedure. After completing the force learning cycle,
the “0” on the display must disappear.
•
The force learning cycle always starts from the end position
CLOSE.
NOTICE
•
Should the “0” on the display not disappear, repeat the procedure.
•
After 3 failed attempts, “3” is displayed and you are prompted to
repeat the setting of the end positions, see also “Menu 3 + Menu 4:
Setting the end positions” on page 58.
C
B
D
