58
NovoPort® IV
4.9.4
Deleting all hand transmitters programmed for the operator
Fig. 4-9
Deleting all hand transmitters programmed for the operator
1.
Pull out the mains plug of the control unit.
2.
Press and hold the PROG button (D).
3.
Plug the mains plug into a socket while keeping the PROG button (D) pressed.
4.9.5
Menu 3 + Menu 4: Setting the end positions
Fig. 4-10
Setting the end positions
1.
Keep the programming button (PROG button) (D) pressed in for approximately
3 seconds. The display shows “3”.
2.
Press the OPEN button (B) and check if the garage door moves to the OPEN
position.
3.
Keep the OPEN button pressed until the garage door is at the desired end
position OPEN. If needed, press the CLOSE button (C) to adjust the position.
4.
Once the garage door is at the desired end position OPEN, press the
programming button (PROG button) (D). The display shows “4”.
5.
When the display flashes, press the CLOSE button (C).
6.
Keep the CLOSE button pressed until the garage door is at the desired end
position CLOSE. If needed, press the OPEN button (B) to adjust the position.
Fig. 4-11
Setting the end positions
NOTICE
The end position OPEN must be at least 5 cm away from the toothed
belt profile stop.
NOTICE
If the garage door moves in the wrong direction, initiate a change of
direction by keeping the programming button (PROG button) (D)
pressed in for approximately 5 seconds until a chaser light appears.
C
B
D
C
B
D
C
B
D
