Page 4 looks like so:
The higher parameter is “Speed 2”. In this case with a value of 080.
This parameter determines the secondary Speed of the Chorus/Flanger/Phaser. The primary speed is determined by the Speed
knob on the front panel. It is possible to switch from the front panel setting to this one using the Wheel function & Wheel level para-
meters on page 6 of this menu. This is particularly effective when using the Rotary Speaker effect but is also applicable to all th
effects on the Chorus/Flanger/Phaser block. Use the upper Data knob to adjust this parameter. The range of this parameter is 000
to 127. This parameter is memorised with a Program in Program Mode or memorised with a Program or Performance in
Performance Mode depending on the value of the Part’s “Part FX” parameter.
The lower parameter is “Inertia”. In this case with a value of 032.
This parameter determines rate at which the speed changes when the effect is switched from the primary speed to speed 2 & vice
versa. This again is particularly effective when using the Rotary Speaker effect but is also applicable to all th effects on the
Chorus/Flanger/Phaser block. Use the lower Data knob to adjust this parameter. The range of this parameter is 000 to 127. This
parameter is memorised with a Program in Program Mode or memorised with a Program or Performance in Performance Mode
depending on the value of the Part’s “Part FX” parameter.
Page 5 looks like so:
The parameter is “Stereo width”. In this case with a value of 032.
This parameter determines how stereo the effect is. Use the upper Data knob to adjust this parameter. With a value of 000 the
effect is Mono. With a value of 127 the effect very stereo The range of this parameter is 000 to 127. This parameter is memorised
with a Program in Program Mode or memorised with a Program or Performance in Performance Mode depending on the value of
the Part’s “Part FX” parameter.
Page 6 looks like so:
The higher parameter is “Wheel mode”. In this case with a value of Threshold.
This parameter determines what the Mod Wheel is assigned to do. Use the upper Data knob to adjust this parameter. When this
parameter is set to FX amount the Mod wheel will control the amount of effect if the “Wheel Level” parameter below is set to any
value other than 000. When this parameter is set to Threshold then the Mod wheel controls the speed of the
Chorus/Flanger/Phaser effect. For example if this parameter is set to Threshold & the Wheel level parameter is set to 010 as
shown, when the Mod wheel is set to any value between 000 & 009 then the Chorus/Flanger/Phaser effect will be modulated at the
front panel Speed setting. When the Mod wheel is set to any value between 010 & 127 then the Chorus/Flanger/Phaser effect will
be modulated at the Speed 2 parameters setting. The range of this parameter is FX amount & Threshold. This parameter is memo-
rised with a Program in Program Mode or memorised with a Program or Performance in Performance Mode depending on the
value of the Part’s “Part FX” parameter.
The value of Speed 2 can be higher than the front panel Speed so that as the threshold is passed the effect will “Speed up”, but
also the reverse can apply, the Speed 2 can be lower than the front panel Speed so that as the threshold is passed the effect will
“Slow down”.
NOTE:
NOTE:
Wheel mode Threshold
Wheel level O1O
Stereo width O32
Speed 2 O8O
Inertia O32
EFFECTS SECTION
103
Summary of Contents for Supernova II
Page 145: ...145 NOTES...
