Page 2 looks like so:
The higher parameter is “Distortion curve”. In this case with a value of +64.
This parameter determines the characteristic of the Distortion effect. Use the upper Data knob to adjust this parameter. With a set-
ting +00 normal clipping type of Distortion occurs. With at +ve value addition symmetrical effects are introduced. With at -ve value
addition asymmetrical effects are introduced.The range of this parameter is -64 to+64. This parameter is memorised with a
Program in Program Mode or memorised with a Program or Performance in Performance Mode depending on the value of the
Part’s “Part FX” parameter.
The lower parameter is “Distortion wheel”. In this case with a value of +00.
This parameter determines How much the Mod Wheel controls the Distortion effect. Use the lower Data knob to adjust this para-
meter. With a setting of -64 the Distortion will be reduced with full modulation of the Mod Wheel, With a setting of +63 the Distortion
will be increased with full modulation of the Mod Wheel. The range of this parameter is -64 to +63. This parameter is memorised
with a Program in Program Mode or memorised with a Program or Performance in Performance Mode depending on the value of
the Part’s “Part FX” parameter.
Pan Level - Knob
This knob adjusts the Pan of the selected Program. Turning this knob fully anticlockwise will pan the sound to the left & fully clock-
wise to the right. The range of this parameter is L 63 to R 63. This parameter is memorised with a Program in Program Mode or
memorised with a Program or Performance in Performance Mode depending on the value of the Part’s “Part FX” parameter.
Menu - Button ( Pan )
When this button is pressed, a series of pages is available on the display containing parameters relevant to this section.
In the Pan section there are 2 pages available. These are selected using the page Up & page Down buttons to the left of the display.
Page 1 looks like so:
The higher parameter is “Pan type” In this case with a value of Autopan.
This parameter determines in what way the panning effects are used. Use the upper Data knob to adjust this parameter. In the
Autopan position the Program is “Panned” automatically from Left to Right & back again. In the Tremolo position both Left & Right
are controlled in sync creating the classic “Tremolo” effect. Another 2 phases are provided L-R & R-L. these are similar to Autopan
but the effect is not symmetrical. The range of this parameter is Autopan, Tremolo L-R & R-L. This parameter is memorised with a
Program in Program Mode or memorised with a Program or Performance in Performance Mode depending on the value of the
Part’s “Part FX” parameter.
The lower parameter is “Pan speed”. In this case with a value of 040.
This parameter determines the rate at which the Autopan & Tremolo effects run. Use the lower Data knob to adjust this parameter.
The range of this parameter is 000 to 127. This parameter is memorised with a Program in Program Mode or memorised with a
Program or Performance in Performance Mode depending on the value of the Part’s “Part FX” parameter.
Pan type Autopan
Pan speed O4O
Distortion curve +64
Distortion wheel +OO
EFFECTS SECTION
105
Summary of Contents for Supernova II
Page 145: ...145 NOTES...
