Novation Supernova II, User Manual

Page: 68 / 148

OSCILLATOR SECTION
Osc1 - Button
Osc2 - Button
Osc3 - Button
1*3 - Button
2*3 - Button
Noise - Button
1*3 - FM - Button
2*3 - FM - Button
Noise - FM - Button
All these buttons “select” which oscillator is going to be manipulated by the other parameters in this section. Osc 1 button selects
Oscillator 1, Osc 2 button selects Oscillator 2, Osc 3 button selects Oscillator 3, 1*3 button selects the output of the Ring Modulator
between Oscillators 1 & 3, 2*3 button selects the output of the Ring Modulator between Oscillators 2 & 3, Noise button selects the
Noise Generator, 1*2 - FM button changes the modulation between Oscillators 1 & 2 from Ring Modulation to FM, 1*3 - FM button
changes the modulation between Oscillators 1 & 3 from Ring Modulation to FM, Noise - FM button changes the modulation
between Oscillators 1 & the Noise source from Ring Modulation to FM.
To adjust the “Octave” setting of Oscillator 1 press the “Osc 1” button, ( it will light up indicating it is selected ) & then press the
“Octave” button within the Tune Part of this section. Adjusting the “Tune” knob will now change the octave setting of Oscillator 1.
The display will change to indicate the parameter that has been selected & display the newly edited value. The Display will stay
like this until another parameter is adjusted, in which case it will change to display the new parameter. To return to the display of
the Program / Performance name & number press the appropriate Program or Performance button.
Only one Oscillator or one of the Ring Modulator / FM or the Noise Source can be selected / edited at one time.
Some parameters do not apply to all sound sources. i.e. The “Octave” parameter has no effect on the Noise generator. If this is
the case, the display will read “Not Available” when the control is adjusted.
Solo - Button
This button is similar to a “solo” button on a mixing console. Pressing this button activates the solo function ( The button is lit ) &
the currently selected sound source will be soloed. When the solo button is active ( lit ) the display will momentarily indicate that
the selected sound source has been soloed. To return to normal operation press the solo button again. ( unlit )
Copy - Button
This button activates a Copying utility & allows the settings of one Oscillator to be quickly copied to another. Pressing the button (
The button is lit ) when Oscillator 1 is selected activates the copying function for Oscillator 1’s parameters to be copied to another
Oscillator & the display shows:
It is now a simple matter of pressing the destination. ( the oscillator that you wish to copy oscillator 1’s settings to ) i.e. Press
Oscillator 2 button & the display shows:
Oscillator 1 copied
to oscillator 2
Copy oscillator 1
to?
NOTE: NOTE:
NOTE:
NOTE:
68