EFFECTS SECTION
The range of this parameter is D+R+C, D>R>C, D>C>R, R>D>C, R>C>D, C>D>R, C>R>D, D+[R>C], D+[C>R], R+[D>C],
R+[C>D], C+[D>R], C+[R>D], D>[R+C], R>[D+C], C>[D+R]. [R+C]>D, [D+C]>R & [D+R]>C. This parameter is memorised with a
Program in Program Mode or memorised with a Program or Performance in Performance Mode depending on the value of the
Part’s “Part FX” parameter.
To use the different configurations, the Config morph parameter should be set to 127. If this parameter is set to 000, the “Normal”
configuration D+R+C applies.
The lower parameter is “ Config morph”. In this case with a value of 000.
This parameter morphs the effect configuration from the “Normal” D+R+C configuration to any configuration selected by the Fx
config parameter. Use the lower Data knob to adjust this parameters value. If this parameter is set to the 00 position the config is
“Normal” D+R+C. If this parameter is set to 127 the configuration will be the one selected by the Fx config parameter. In-between
this, the configuration is somewhere between the two. This allows many interesting “Cross connections” to occur between the dif-
ferent effects blocks. The range of this parameter is 000 to 127. This parameter is memorised with a Program in Program Mode or
memorised with a Program or Performance in Performance Mode depending on the value of the Part’s “Part FX” parameter.
Page 7 looks like so:
The parameter is “Pass to effects:”. In this case with a value of Program only.
This parameter allows the Audio Inputs to be connected into the effects. Use the Lower Fast Data knob to adjust this parameter. If
this parameter is set to Program only then the Program only will be connected to the effects chain of the program or Part if in
Performance mode. If this parameter is set to Audio input (1) only then the Audio from Input/sw 1 will be will be connected to the
effects chain of the Program or Part if in Performance mode & the Program will be disconnected. If this parameter is set to
Program & input (1) only then the Audio from Input/sw 1 & the Program will be will be connected to the effects chain of the
Program or Part if in Performance mode. Similar values are provided for Audio Input/sw 2. The range of this parameter is Program
only, Audio input (1) only, Program & input (1), Audio input (2) only & Program & input (2). This parameter is memorised with a
Program in Program Mode or memorised with a Program or Performance in Performance Mode depending on the value of the
Part’s “Effects Used” parameter.
Page 8 looks like so:
.
The parameter is “Effects bypass:”. In this case with a value of Off.
This parameter allows all the effects to be switched off or bypasses so that the raw program can be auditioned.. Use the higher
Fast Data knob to adjust this parameter. When this parameter is set to On all effects are bypassed & only the dry sound of the
synth will be heard. The range of this parameter is On & Off. This parameter is memorised with a Program in Program mode or
memorised with a Program or Performance in Performance mode depending on the value of the Part’s “Part FX” parameter.
Effects bypass Off
Pass to effects:
Program only
NOTE:
NOTE:
110
Summary of Contents for Supernova II
Page 145: ...145 NOTES...
