Page 16 looks like so:
The Supernova II Rack features a “Program Change table” mode that allows any incoming MIDI Program Change message or
Keypad selection to call up any Program or Performance from any Bank, or select a new Arpeggiator Pattern for the currently
selected program. The Program Change table is user programmable & is memorised as Global. To select the Program Change
table via MIDI send a Bank Message of 0 ( Controller 32 with a value of 0 ). When this Bank is selected any incoming MIDI
Program Changes conform to the sequence in the Program Change table. Assigning Programs, Performances & Arp patterns to
Favourite locations can be done with the assign button in the Mode section.
The higher parameter is “Prog change”. In this case with a value of 002.
This parameter shows which Part of the Program Change table will be displayed / Edited. Use the higher Data knob to adjust this
parameter. The Program Change table allows incoming MIDI Program Change Messages to call up any sound in the Supernova II
Rack. This not only allows master keyboards & sequencers that do not support MIDI Bank Select Messages access to any sound
via MIDI but also allows a user “Order” of sounds to be created which can be very useful in live performance. The range of this
parameter is 000 to 127. This parameter is memorised as Global.
The Program map can be made active at all times by setting the “Incoming program change” parameter on page 13 of the Global
mode to “Program Change table”.
When a Program/Part receives a valid Bank Select Message (Controller 32) via MIDI IN, the bank will continue to remain selected
for the Program/Part until another Bank Select Message is received via MIDI IN.
This “Program change table” is assigned to MIDI Bank 0( Controller 32 with a value of 0 ). If this message is received the
Supernova II Rack will switch from normal operation to the Program Change table. Any Program changes received after that will be
re-mapped according to the Program Change table. This can be disabled by sending another MIDI Bank Message calling up either
one of the Program or Performance Banks. See page 125 for details on the Bank Messages received by Supernova II Rack.
To write any changes to the performance map into memory press the “Write” button while this page is displayed. Also note the
“Memory Protect” has to be set to “Off” for this to be possible.
The lower parameter is “Selects”. In this case with a value of Perf A010.
This parameter shows which sound is assigned to the selected Program Message set in the parameter above. Use the lower Data
knob & the Bank button to adjust this parameter. In this case the sound assigned is Performance A010. Pressing the Bank button
while in this mode allows the selection of any of the Performance or Program Banks. Using the lower Data knob allows any sound
from the selected Bank to be set. The range of this parameter is Curr, Prog A, Prog B, Perf A, Arp M ( Mono patterns ), Arp P ( Poly
Patterns ) & Arp U ( User patterns ). This parameter is memorised as Global.
Page 17 looks like so:
The parameter is “Arp pattern editing via MIDI”. In this case with a value of Off.
This parameter determines if the Arpeggiator pattern data can be entered via the master keyboard or not. When this parameter is
set to Off, no editing of Arpeggiator patterns via MIDI is possible, only the step type editing on pages 19 of the Global mode. If this
Arp pattern editing
via MIDI Off
NOTE:
NOTE:
NOTE:
NOTE:
NOTE:
NOTE:
NOTE:
NOTE:
Program change OO2
Selects Perf AO1O
50
MODE SECTION
Summary of Contents for Supernova II
Page 145: ...145 NOTES...
