- 59 -
1601_GB-MAINTENANCE_3846
MAINTENANCE
GB
Setting the field transport position (headlands FT)
1170 mm
10
10
S1
S2
2 mm
11
The following guide is valid for both cutter bars.
1. Set the gap (2 mm) between the sensor and the disc
2. Raise both cutter bars until the hydraulic cylinders have
retracted to a measurement of "1170 mm".
3. Loosen the disc screws (11).
4. Move the disc (10) along the slot until the edge is
located almost at the sensor (S1).
3. Retighten disc screw fittings.
Set sensors
Adjustments and checks must always be carried out in
the operating position where the distance from the sensor
is smallest.
There is also a possible assembly clearance to consider.
Gap 2 mm
