- 36 -
1401_GB-ISObus Terminal_3846
ISOBUS TERMINAL
GB
Configuration menu
In the START Menu (
F6
) press and hold the “Set” key
for 10 seconds to open the Configuration Menu.
a
b
c
D
E
f
a
Swivelling assistance
Deactivate this configuration with Novacat X8, X8
Collector and V10!
b
Single cross conveyor swivelling
(only with Novacat X8)
c
Inputs/outputs diagnosing function
D
Hydraulic relief
E
Cross conveyor belts speed regulator
(only with Novacat X8)
f
Curved cut optimisation:
(only Novacat V10)
(Tick = active / cross = inactive)
Angle sensor malfunction:
It cannot be automatically determined if the machine
exceeds the max. transport height of 4m.
Diag
Countermeasures:
Minimize sideways movement using emergency activation
on hydraulic block.
Causes:
- Defective angle sensor (S11, S12)
- Defective supply line to angle sensor
Warning: Mower units are not in neutral position
Diag
There are two possible causes for this warning to occur:
1. The mower units are not in neutral position therefore
filling the hydraulic relief is impossible.
2. The cardan shaft is rotating and the mower is in the
working position, but not in the neutral position, and
the tractor speed is greater than 0 kph.
