Nostolift XS240, Operation & Maintenance Manual

Page: 53 / 75

®
XS
240
SELF-PROPELLED TELESCOPIC PLATFORM
- Operating point stickers
21.3 GENERAL REQUIREMENTS
21.3.1 Manual
A manual must always be kept with the Access Platform.
21.3.2 Locker for manual
The manual must always be kept in the equipment case.
21.3.3 Manufacturer's plate
The manufacturer's plate of the Access Platform must be unbroken and clearly marked.
The plate has been riveted onto the chassis next to the equipment case.
21.3.4 Load plate
- SWL (=safe working load) given as the allowable number of persons and weight of
additional load as well as the maximum permitted lateral load caused by the persons must
be marked indelibly and clearly in a visible place on the platform.
- The load plate, located on the outer edge of the platform, must be replaced if it is not
readable or if it is broken.
- A sticker or a paint mark will do, because the lost information can, if needed, be replaced
with new one available on the manufacturer’s plate.
- The calculated weight for the first person is 80 kg and for the next one 80 kg, leaving 70
kg for the weight of equipment.
- The weight of equipment of 70 kg and the maximum permitted lateral load of 400 N = 40
kg are shown on the load plate.
- The second load plate is located beside the valve for ground operating.
21.3.5 Warning plate
The ground operating point and the platform of the Access Platform are fitted with the
following warning plates. On the engine cover, there is also an instruction sticker for
operating the emergency lowering system.
-
Working near live electrical conductors
- Plate with instructions for operating the outriggers: SECURE STABILITY.
EVEN ASPHALT CAN YIELD!
- Maximum working load
- Voltage sticker
- Warning of high sound intensity
- Inspecting the condition of Access Platform and trial operation before starting
actual work (= daily check)
- Steps to be taken in case of malfunction during Access Platform operation
52