Nostolift XS240, Operation & Maintenance Manual

Page: 54 / 75

®
XS
240
SELF-PROPELLED TELESCOPIC PLATFORM
- General instructions for the operators
21.3.6 Plate for outriggers
The maximum supporting load and instructions regarding the use of extra plates must be
indelibly and clearly marked at the place where the outriggers are used.
With the boom slewed above the outrigger in question at the maximum working load, the
supporting load is 37000 N = 2550 kg.
The soil tightness table in the manual will help to define the need for extra plates.
- Potential building instructions or requirements regarding each separate site must be
considered separately.
- Maximum supporting load = 37000 N, on soft ground extra plates must be used under
the outriggers.
21.3.7 Hazard colours
The Access Platform must be easily visible. All projecting parts must be clearly marked.
Projecting parts are the extremities which reach outside the actual chassis, like outriggers
and the platform. Being most easy to see, yellow/black diagonals are used for marking.
General about the markings:
- The stripes are marked on the Access Platform with yellow/black stickers
-There are stripes on the sides of outriggers and on the base strip of the platform
21.3.8 Operating zone scheme
For the scheme of the operating zone, refer to chapter BOOM GEOMETRY, page 11.
21.3.9 Inspection plate
The inspection plate, onto which the inspector stamps his initials and the date, is riveted
on the equipment case.
21.4 SAFETY REQUIREMENTS
21.4.1 Indicator of horizontal level
The Access Platform is correctly supported when all four lights of the indicator, located on
the control panel of the platform, are lit while the boom is on the transport support. The
actual switch for horizontal level is situated on the turntable, ac0.5º – 1.0º.
21.4.2 Prevention of raising the platform
53