Sole plate
®
XS
240
SELF-PROPELLED TELESCOPIC PLATFORM
Figure 17
WHEN THE GROUND SENSOR ALARM IS ACTIVATED, LOWER THE BOOM
IMMEDIATELY TO THE TRANSPORT POSITION. CHECK THE TIGHTNESS OF THE
GROUND, REFER TO THE SOIL TIGHTNESS TABLE. CORRECT THE POSITION OF
THE OUTRIGGERS SO THAT ALL FOUR OUTRIGGERS HAVE FIRM CONTACT WITH
THE GROUND.
13.8.1 Safety instructions
- Do not add load to the platform when the movements of the boom have stopped after the
limiter of the lifting radius has intercepted the movements of the boom. Extra load would
cause a risk of tipping over, and a large extra load could cause overloading of the boom.
- Do not use the Access Platform if the safety limits or the limiters of the lifting radius are
not working. If you are not sufficiently familiar with the maintenance of Access Platforms,
contact an expert. It is absolutely prohibited to override any safety device, sound alarm or
indicator light even for a minor job.
- Check, with the boom and jib slightly raised and the telescope slightly extended, that no
movement is ”creeping” and that the platform does not move downwards when the
controls are in the middle position. Load the platform with a proper extra load during the
test. The creeping must be repaired before starting to work.
- If needed, check the creeping of the outrigger cylinders in the position shown in figure 12
by slewing the boom above each outrigger and holding the boom there for about two
minutes. If a cylinder retracts, have it repaired immediately.
- The platform load control does not remove the risk of tipping over caused by the addition
of sudden load at the maximum lifting radius.
- The platform must not be used for lifting materials or supplies.
- An additional load of a maximum of 70 kg can be loaded into the platform.
14CHECKING THE VOLUME OF AND ADDING
HYDRAULIC OIL
The hydraulic oil tank of Nostolift XS 240 has a level switch which is connected to the
control system of the Access Platform. The display on the platform indicates if the level of
hydraulic oil is too low. The hydraulic oil tank must always be filled in accordance with this
instruction.
- Remove the left side guard.
35
Summary of Contents for XS240
Page 1: ...XS240 SELF PROPELLED TELESCOPIC PLATFORM OPERATION MAINTENANCE...
Page 6: ...XS 240 SELF PROPELLED TELESCOPIC PLATFORM 4 SPECIFICATION Figure 3 Specification 5...
Page 10: ...XS 240 SELF PROPELLED TELESCOPIC PLATFORM 5 1 NOSTOLIFT XS 240 BOOM GEOMETRY 9...