Nortel 703t, Maintenance And Diagnostics, Page: 152 / 248

Replacing media drives Standard 1.06
152 CallPilot
6 Reach your fingers between the fan holder foam inside the server
and the hard drives, and carefully disconnect the power and signal
cables for both hard drives.
Note: If you are able to disconnect the cables for only the hard drive
you want to remove, that is acceptable. You may find it easier,
however, to disconnect the cables for both hard drives.
7 Pull the drive carrier out of the chassis, and then place it cage-side-
up on an antistatic surface..
8 Remove the new drive from its protective wrapper, and place it on
an antistatic surface.
9 Record the drive model and serial numbers in your equipment log.
10 Set the hard drive settings as described in “Hard drive
configuration” on page 148.
For instructions on changing the hard drive’s settings, refer to the
drive manufacturer’s documentation.
11 If you are replacing an existing hard drive, remove the old drive
from the drive carrier as follows:
a. Remove the four screws that attach the drive to the carrier.
b. Lift the carrier off of the hard drive.
c. Place the drive in an antistatic protective wrapper.
12 Position the new drive component-side down inside the drive
carrier, and then attach the four screws that you removed earlier.
Ensure that the connectors on the back of the drive are flush with
the rear of the drive carrier.
13 Continue with “To install the hard drive” on page 153.
.
CAUTION
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive components.