Nortel 703t, Maintenance And Diagnostics

Page: 148 / 248

Replacing media drives Standard 1.06
148 CallPilot
Hard drive description
The server is equipped with two 36 Gbyte wide SCSI hard drives, each
one inch high. The last bay must remain empty to ensure proper system
cooling.
SCSI drive cabling
The hard drive assembly package includes a standard 68-pin, 68
conductor, twisted-pair wide (16-bit) SCSI ribbon cable, with
terminator. This cable has three connectors: the first is for the terminator,
the second is for the hard drive, and the third is for connection to the
RAID card.
Hard drive configuration
Ensure that the hard drives are configured as follows (for instructions,
refer to the original equipment manufacturer documentation):
„
termination: Set the hard drive on each SCSI bus to provide
termination power to the bus.
„
active termination (Term Enable): disabled on both drives
„
parity checking: enabled on both drives
„
all other settings: factory default
.
CAUTION
Risk of equipment damage
The internal SCSI interface in this system supports only
single-ended SCSI devices. Use Nortel authorized
drives only.
ATTENTION
If there is a termination enable jumper on the drive, it
must NOT be set.
Termination must be provided by a SCSI terminator
attached at the end of the cable.