Nordson Encore iControl 2, Configuration, Preset Setup, Operation

Page: 34 / 168

Standard System Configuration
3-14
Part 1056418-07
E 2019 Nordson Corporation
Using Zone Inputs for Direct Triggering
(contd)
To turn on guns 1 − 16 then, turn on inputs 1 − 8, strobe input 19, then turn on
input 17 and strobe input 19 again. To turn off the guns, turn on input 17
and strobe input 19, turn off input 17 and strobe input 19 again.
Manual Trigger Lockout
When Direct Triggering is selected, input 23 can be used to lockout manual
gun triggering. When input 23 is turned on the guns cannot be manually
triggered.
Part ID Input Configuration
The iControl system provides eight digital part ID inputs for use with
photoeyes, discrete scanners, or a customer-supplied part identification
system (such as a bar code reader) that sends the inputs an 8-bit binary
number corresponding to the part ID.
The part ID inputs must receive the part ID signal before the zone
photoeyes or scanners detect the part.
If using part ID flags, position the photoeyes or scanners:
S
in the same vertical plane as the zone photoeyes or scanners if the
part ID flag is leading the parts.
S
ahead of the zone photoeyes or scanners, if the part ID flag device is a
integral with or attached to the part hanger.
See Figure 3-2. Open the Photoeye/Scanner Configuration screen from
the System Configuration screen. Select the part flagging method and the
flag filter length. Explanations for each method and filter use are provided
on the following pages.
Encoded Flagging
Straight Flagging
Flag Filter
Figure 3-11 Photoeye and Scanner Configuration Screen − Configuring Part ID Inputs
NOTE: If you change the flagging method you must reboot the system for
the change to take effect. Use the Program Shutdown/Reboot procedure
(page 3-33) and select Shutdown and reboot on the operating system
dialog box.