Nordson Encore iControl 2, Configuration, Preset Setup, Operation

Page: 118 / 168

Reciprocator Preset Settings
7-2
Part 1056418-07
E 2019 Nordson Corporation
Reciprocator Preset Screens
See Figure 7-1. To set up a preset for a reciprocator:
1. Use the Preset Selector to select a preset number first. All settings you
make apply to that preset.
NOTE: If no changes have been made to the preset settings since the
screen was opened, the Not Modified icon is displayed. If you make a
change, the Modified icon is displayed instead.
2. If you want to view the Default Settings for a reciprocator, use the
Reciprocator Selector . The default settings are displayed in the row to
the right of the selector.
3. Make preset settings for each reciprocator as desired. The mode set
during reciprocator configuration determines which preset settings are
available. The mode is shown along with the reciprocator number.
Refer to Fixed Mode Settings or Variable Mode Settings on the following
pages.
4. If desired, enable percent adjust and make settings as desired. Refer to
Percent Adjust Settings on page 7-6.
Copying Preset Settings
The Copy button copies the selected preset settings from Reciprocator 1 to
the rest of the reciprocators.
To select a setting to copy, touch the setting label. When selected, an X
appears in the selection box on the label.
Saving Preset Settings
The Save button saves the preset settings to the user database. If you
close the screen without touching the save button, you will be prompted to
save or cancel your changes.
Reset to Defaults
The Reset button clears the values in the selected preset. The reciprocator
will then use the configured default values for that preset. Refer to
Reciprocator Configuration in Section 4.