Nordson Encore iControl 2, Configuration, Preset Setup, Operation

Page: 42 / 168

Standard System Configuration
3-22
Part 1056418-07
E 2019 Nordson Corporation
Shift Register Reset
Use this function to clear the shift register if the system loses track of the
parts in the booth. This happens if you reverse the direction of the conveyor
while parts are in the booth, since the iControl system does not track the
direction of conveyor movement.
Triggering Rules
Original Rule: This is the default rule. If a system is upgraded to iControl
3.0 software from a previous version, and the system has already been
configured, this rule will be selected by default.
Under this rule, the preset of a new part takes priority. Therefore, as soon
as the lead of a new part is reached, the spray guns start spraying with the
new preset settings, even if the trailing edge of the previous part has not
been reached, or lag of the previous part has not been completed.
NOTE: This rule may cause erratic triggering. For example, the new preset
may cause guns to spray when they would normally be off for the current
preset.
Previous Part
Preset 21
Next Part
Preset 18
Preset 18 Starts Spraying Here
Lag Lead
Lag
Lead
Direction of Travel
Figure 3-18 Original Triggering Rule
Lead Priority: This rule mandates that the lead of the next part will not
start until the trailing edge of the previous part is reached if the new lead
overlaps the previous part.
NOTE: When installing iControl 3.0 software on a new system that has no
configuration, or updating an older system without an existing database, the
Lead Priority rule is the default selection.
Previous Part
Preset 21
Next Part
Preset 18
Preset 18 Starts Spraying Here
Lag Lead
Lag
Lead
Direction of Travel
Figure 3-19 Lead Priority Triggering Rule