Nordson Encore iControl 2, Configuration, Preset Setup, Operation

Page: 108 / 168

Spray Gun Preset Settings
5-20
Part 1056418-07
E 2019 Nordson Corporation
Copy Selected: Gun Control Screens
The Copy Selected function allows you to select preset settings for a range
of guns and a range of presets (source), and copy the settings to a different
range of guns and range of presets (destination). This function is only
available on the Gun Control screens.
NOTE: Use the Global Control screen to shut off all guns before using this
function. The iControl system will not allow copying while the guns are in
Auto or Manual mode. To copy selected settings:
1. See Figure 5-19. Touch the
Copy Selected button to open the Copy
Selected screen.
2. Select the:
a. Source settings. You can select more than one setting. When
selected the setting buttons turn green.
b. Source range of guns.
c. Source preset or range of presets.
d. Destination range of guns.
e. Destination preset or range of presets.
NOTE: All selections must be valid or the Copy Start button will not
function. If the button is gray, check your selections for errors such as an
unequal number of source and destination presets.
3. Press the
Copy Start button. The Copy Selected dialog appears.
S
All guns must be turned off. If they are not, the Copy button will not
function. Use the Global Control screen to turn all guns off.
S
If you wish to cancel the copy operation, touch the Exit button.
4. Press the Copy button to start copying.
5. When the copy operation is complete, the screen closes automatically.
Copy Selected
Copy
Source Guns
Source Presets
Destination Guns
Destination
Presets
Copy Start
Selected
Source Settings
Figure 5-19 Zone Assignments