Nordson Encore iControl 2, Configuration, Preset Setup, Operation

Page: 41 / 168

Standard System Configuration
3-21
Part 1056418-07
E
2019 Nordson Corporation
Pickoff Configuration
See Figure 3-2. Touch the Pickoff Configure button on the System
Configuration screen to open the Pickoff Configuration screen.
NOTE: You must configure the guns first or the correct number of guns will
not be displayed on the Pickoff Configuration screen. Refer to page 3-4.
Save
Keypad
Pickoffs
Shift Register Reset
Booth Length
Triggering
Rule
Selection
Triggering
Rule
Help
011
Figure 3-17 Pickoff Configuration
Pickoffs
The pickoff is the distance from the zone photoeyes or scanners to each
gun. Enter pickoffs for each of your guns. To use the keypad to enter large
numbers, first touch the data field, then the Keypad button.
NOTE: The maximum length at an encoder resolution of 1 inch is 4096
inches (104038.4 mm). If you enter a number larger than this the value is
forced to 4096 when saved. Finer resolutions result in lower maximum
settings.
Length of Booth
Enter the length of the booth, from the zone photoeyes or scanners to the
end of the booth. This value is used for automatic color change operations
to ensure that all parts have cleared the booth before gun purging starts.