Nidek Medical ICE mini, Operator'S Manual

Page: 86 / 93

76
CONNECTION AND SETTINGS : Connection
{ Settings of the LT-900
To directly connect the LT-900 to the ICE mini, connect the LT-900 to the TRACER connec-
tor of the ICE mini.
*1: Changing the settings needs a PC and Tracer Utility software.
*2: Set the S1 (or RATE) switch on the side circuit board (BA15) of the tracer upward.
{ Settings of the ME-1000
*1: Set the parameters on the Setting-Communication screen.
*2: Set the parameters on the Network screen.
*3: Never change the factory setting of Mac Address that had been set uniquely for each individual
ME-1000 before shipment.
*4: Set these parameters in accordance with the network to which the ME-1000 is connected. Select
TCP when the PC is connected.
Parameter Mini LAB
*1 Setting - Communication STD
*2 Baud Rate
Select the same baud rate as
the LT-900.
Parameter Blocker/LE
Mini LAB
(when the ETHERNET
port is used)
Blocker LAB
*1 Communication Interface
It is impossible to
connect the ME-1000.
LAN LAN
*1 RS-232C Baudrate —
—
*1 Communication Port ETHERNET ETHERNET
*1 Transport Protocol TCP TCP
*2 Host ID 32 32
*2 My ID
ME-1000 ID No.
(Any number except for
the SERVER No.)
ME-1000 ID No.
(Any number except for
the SERVER No.)
*2 MAC address
Never change the
factory setting. *
3
Never change the
factory setting. *
3
*2 IP address
Set the parameter
uniquely for each
individual ME-1000. *
4
Set the parameter
uniquely for each
individual ME-1000. *
4
*2 Subnet mask
Set the parameter
uniquely for each
individual ME-1000. *
4
Set the parameter
uniquely for each
individual ME-1000. *
4
*2 Gateway
Set the parameter
uniquely for each
individual ME-1000. *
4
Set the parameter
uniquely for each
individual ME-1000. *
4
*2 Host IP Address
PC: PC IP address
ICE mini: ICE mini IP
address
PC IP address