Installa
ti
on instruc
ti
ons for the IMM'Ax automa
ti
c immersed safety cover - 12/36
12
Fig. 25
Fig. 26
Fig. 27
2.5cm < x < 7cm
4. Assembling the cover
Special care needs to be taken when handling the slats. A
shear strain on them can cause irreversible damage to the
caps; this is why they must not be assembled by threading.
4.1 Placing the slats on the water
Fig. 25
- Transfer the slats directly from the container to the pool
water avoiding all mechanical contacts.
- Prevent the slats from rubbing against the ground.
- Place the packets of slats directly onto the water, curved
side towards the sky and the double male hook on the
side opposite the roller. Place the speci
fi
c groups of slats
(the group
fi
tt
ed with straps to hook to the sha
ft
on the
roller side, the group fitted with the other anti-lifting
mechanisms on the side opposite the roller, and the slats
for the stairs).
4.2 Assembling the packets of slats
Fig. 26
- Assemble the slats by clipping them together by inser
ti
ng
the double male hook into the female part of the preceding
slat and then by pushing the slats up into a "V" shape
towards the sky.
- Make oscilla
ti
ng movements in order to cause click-
fi
tti
ng
along the whole length of the slat.
4.3 Checking the gap
Fig. 27
- Place the cover against a length of the pool. Check that
there is a gap greater than 2.5 cm between the ends of
the wings and the sides of the pool (needed for opera
ti
on)
and less than 70 mm (otherwise the cover is no longer
compliant).
- Check that in the roller trench, this gap between the
fl
anges
and the ends of the wings is at least 20 mm.
- 10, 15, 20, 25 and 30 mm wings are available on order.
