15/36 - Installa
ti
on instruc
ti
ons for the IMM'Ax automa
ti
c immersed safety cover
15
4.7 Fixing with the Coverlock system
Make sure to posi
ti
on the harpoons and triggers in rela
ti
on
to one another to obtain perfect alignment and correct
opera
ti
on.
4.7.1 Fig.
34
Posi
ti
on each front harpoon
1
on the male part of the
last slat of the apron using two TFPZ 3x16 mm screws.
Once all of the necessary harpoons have been installed,
cut the remaining male part of the slat using a cu
tt
er and
a metal saw. This will protect the liner from any damage.
4.7.2 Fig. 35: Fixing the triggers in the wall:
Mark out the holes by placing the part
2
in the centre of
the harpoon.
Drill to a diameter of 6 mm and depth of 35 mm.
Fix the part
2
using the TRHC M5x30 mm screws and M5
brass plugs.
Make sure that this is horizontally level.
Fix the face on the part
2
using the TRPZ 4x16 mm
screws.
4.7.3 Fig. 36: Op
ti
on for
fi
xing the triggers on the edge:
Fix the part
2
on the support
3
using the TFHC M5x16
mm screws and the M5 nuts.
Then, assemble the support
3
on the edge plate
4
using the TFHC M5x16 mm screw, the whole forming an
angle bracket.
Centre the whole on the harpoon, then correctly
fl
a
tt
en
the support and the edge plate against the pool wall and
edge.
M a r k o u t t h e h o l e s a n d d r i l l t o
a diameter of 8 mm and depth of 35 mm.
Finally,
fi
x using the TFHC M6x30 mm screws and M6
brass plugs.
The front face of the trigger is
fi
xed on the part
2
using
the two TRPZ 4x16 mm screws.
4.7.4 Fig.
37
Close the cover to connect the system.
4.7.5 Fig.
38
Secure the pool by pressing on the trigger.
Fig. 34
1
Fig. 35
1
2
Fig. 36
1
2
4
3
Fig. 37
Fig. 38
