Installa
ti
on instruc
ti
ons for the IMM'Ax automa
ti
c immersed safety cover - 8/36
8
3.2.2 Assembling the sha
ft
and the
fl
anges
Fig. 10
- Assemble the motorised tube to the
fl
ange at the opposite
end of the motor following these steps:
•
fi
t the stop ring to the bearing sha
ft
which is used to
stop the bearing sha
ft
from sliding,
•
fi
t the black bearing to the bearing sha
ft
,
• place the 8 mm pin onto the sha
ft
and slide the black
bearing to hold it by covering the pin and the end of the
sha
ft
,
•
fi
x the black bearing to the bearing
fl
ange using M10
nuts. Thus the pin is trapped in the black bearing against
the
fl
ange.
Fig. 11
- Assemble the motorised tube with the
fl
ange on the motor
side by inserting the motor end into the conical black
bearing.
- Pin the motor end to the bearing shaft using the pin
(stainless steel ring diameter 10 mm) making sure that the
pin crosses the motor sha
ft
completely.
- Pass the motor cable behind the central embossing of the
fl
ange between the pin and the pool and bring it out in the
upper part of the embossing.
- Posi
ti
on the pin block.
- Place the TFHC M10x60 screws.
- Manually screw the plugs on these screws to slightly extend
the plugs.
3.2.3 Installing the roller
Fig. 12
- Slide the bearing sha
ft
into the tube to shorten the
whole.
Fig. 13
- Lower the assembled roller into the pool.
Fig. 13
Fig. 12
Fig. 10
Fig. 11