27/36 - Installa
ti
on instruc
ti
ons for the IMM'Ax automa
ti
c immersed safety cover
27
27
6.3 Tes
ti
ng the run stops
Opera
ti
on:
Fig. 64
Cover in open run stop posi
ti
on. The
fi
rst slat of the apron
has passed the top sensor strip, it falls and is therefore not in
front of its detector.
Opening of the system stops.
Fig. 65
The cover starts opera
ti
ng again during closing. The apron
unrolls on the pool.
Fig. 66
Cover in closed run stop posi
ti
on. The last slat of the apron
has passed the bo
tt
om sensor strip, it falls and is therefore
not in front of its detector. Closing of the system stops.
Warning, if closing is incorrectly stopped:
- cover stopped too soon, there is a space over the pool.
- cover stopped too late, the slats are compacted and li
ft
up
from the surface of the water.
Adjust the number of slats on the pool or remove slats).
6.4 Uncoupling
6.4.1 Switch
o
ff
the box.
6.4.2 Block
the
rota
ti
on of the sha
ft
while keeping the slats
rolled around.
6.4.3 In the connec
ti
on box located close to the pool,
disconnect the power wires (+ and -) from the motor
cable in order to slide it completely towards the sha
ft
.
The cable must be completely free from any constraints.
6.4.4 Remove the pin block to access. Turn the stainless steel
pin a quarter turn so that it is perpendicular to the wall,
and pull. The cover axis now rotates freely.
6.4.5 Manually accompany the unrolling of the cover, making
sure that the motor cable does not get entangled.
6.4.6 Lock the safety mechanisms.
6.4.7 When commissioning the roller, a new adjustment of the
motor end of run stops will be needed.
Fig. 64
Fig. 65
Fig. 66
