23/36 - Installa
ti
on instruc
ti
ons for the IMM'Ax automa
ti
c immersed safety cover
23
Fig. 54
Fig. 55
Fig. 56
5s
Auto
Led
0
0UV. FERM.
0
0UV. FERM.
Auto
5s
LED
5.2.2 Adjus
ti
ng the run stops
Fig. 54 - 55 - 56
- Switch on the box.
- Switch the box's switch to "Manual".
- Using the control key, ac
ti
vate the cover and check that
the direc
ti
on of rota
ti
on of the sha
ft
corresponds to the
request. (The slats must always pass over the sha
ft
).
- In the box, invert the motor power wires, connected on the
"red" and "black" terminals, if this is not the case.
- Switch the box's switch to "Auto".
- Ini
ti
alise the programming by pressing the yellow push
bu
tt
on (approx. 5 seconds), and releasing when the LED
fl
ashes.
- Using the control key, completely roll-in the cover.
- The key can be turned several
ti
mes during opening to
adjust the cover to the op
ti
mum posi
ti
on. (the key can be
released then turned again during opening).
- The posi
ti
on of the Opening run stop is stored in memory
while turning the key during Closing.
- Validate this posi
ti
on by closing the pool using the control
key.
- Unroll the cover.
- The key can be turned several
ti
mes during closing to adjust
the cover to the op
ti
mum posi
ti
on. (the key can be released
then turned again during closing).
- The posi
ti
on of the Closing run stop is stored in memory
while turning the key during Opening.
- Validate this posi
ti
on by opening the cover using the key.
- Once the pool is open, close it again.
- The end of run stop adjustment is complete.
5.3 Uncoupling
- Switch o
ff
the box.
- Block the rota
ti
on of the sha
ft
while keeping the slats rolled
around.
- In the motor connec
ti
on box located close to the pool,
disconnect the sensor wires and the power from the motor
cable in order to slide it completely towards the sha
ft
. The
cable must be completely free from any constraints.
- Remove the pin blocker to access. Turn the stainless steel
pin a quarter turn so that it is perpendicular to the wall, and
pull. The cover axis now rotates freely.
- Manually accompany the unrolling of the cover, making
sure that the motor cable does not get entangled.
- Lock the safety mechanisms.
When commissioning the roller, a new adjustment of the
motor end of run stops will be needed.
