Nexo GEO S12 Series, User Manual

Page: 83 / 112

GEO S12 – RS15 / CD18/S2/GEOSUB S
YSTEM
C
HECK
L
IST
Page 83/112
12 GEO S12 – RS15 / CD18/S2/GEOSUB S
YSTEM
C
HECK
L
IST
It is essential to execute all these check steps prior to perform a sound check on the “front end” to the
system. Following this checklist step by step will prevent many troubles and will save time in the end.
12.1 Are the NX242 Digital TDcontrollers properly configured?
IMPORTANT
If you must change any of the parameters listed above, make sure that you use the same
values on all NX242’s.
12.1.1 NX242 settings
Output Assignment
NX Setup / NXChannel 1 2 3 4
GEOS12 Passive 4 Channels GEO S12 Ch1 GEO S12 Ch2 GEO S12 Ch3 GEO S12 Ch4
RS15 Omni Stereo - GEOS12 Passive Stereo RS15 Left RS15 Right GEO S12 Left Geo S12 Right
RS15 Cardio Mono - GEOS12 Passive Stereo RS15 Rear RS15 Front GEO S12 Left Geo S12 Right
S2 Stereo– GEOS12 Passive Stereo S2 Left S2 Right GEO S12 Left Geo S12 Right
CD18 Mono – GEOS12 Passive Stereo
(1)
CD18 Rear CD18 Front GEO S12 Left Geo S12 Right
GEO SUB Mono - GEOS12 Passive Stereo
(1)
GEO SUB Rear GEO SUB Front GEO S12 Left Geo S12 Right
GEOS12 Active 2 Channels GEO S12 LF Left GEOS12 HF Left GEO S12 LF Right GEO S12 HF Right
RS15 Cardio – GEOS12 Active Mono RS15 Rear RS15 Front GEO S12 LF GEOS12 HF
CD18 – GEOS12 Active Mono CD18 Rear CD18 Front GEO S12 LF GEOS12 HF
GEO SUB – GEOS12 Active Mono GEO SUB Rear GEO SUB Front GEO S12 LF GEOS12 HF
Output parameters
Output
Label
Amp
Gain
(2)
Amp
Power
(2)
Global
Gain
Global
Delay
Sense
Gain
Array EQ
(3)
Headrom
(4)
All channels 26 dB refer to amp 0 dB 0 ms 0 dB 0 5 bars
(1) Local gain and delay values are inter-locked channel 1&2
(2) values for recommended amplifier gain and power : should be set in agreement with selected
amplifiers specifications
(3) Should be in agreement with implemented cluster; acts on a shelving filter designed to compensate
for LF coupling.
(4) Disabled when using digital inputs.
12.2 Are the amplifiers properly configured?
Freq. Band Mode Gain Switch Limiter High Pass
All channels Stereo 26 dB None None
12.3 Are the amps and the NX properly connected?
Check that the sense lines on the NX242’s are properly connected by applying a signal to the
corresponding output and verify that the correct Sense LED illuminates.