88
With the tile out of the ceiling grid, snap the fixture hangers over the grid "T"
section as shown.
Figure 3 – Snap on fixture hanger detail
Adjust the clips on the upper plate to match the fixture hanger orientation.
Note that the clips can swivel on both the fixture hanger and the upper plate to
match the ceiling grid layout.
Align the upper plate and fixture hangers with the tile in place to get ready for
the next step.
Final Assembly
Start with the upper plate in the ceiling, locked to the fixture clips and hangers.
Then slide the camera into the hole from underneath, and lock the plates
together with the (4) ¼-20 x 1.5" socket cap screws.
In some areas you may be required to wire anchor the camera and fixture
hangers. Check your local building codes.
Summary of Contents for T-DAR T1000
