44
2. On the monitor tab in the user interface, change the Display mode to Show
Camera Views.
3. Observe the video monitor and note the change in the video on the screen
when this change is made.
a. If any video signals are missing, or if any of the signals are rolling or
noisy, please refer to the troubleshooting section for further assistance.
4. If a T-2000 two-door system is to be set-up,, each Portal is set-up
independently. After set-up of Portal 1, change from Portal 1 to Portal 2 using
the pull down box and repeat step 3.
5. In the user interface, change tabs to the Setup I/O tab
6. Set the time and date on the controller
7. Give the T-DAR system Portals a logical name in the Portal Name space
8. Verify that all of the alarm devices are enabled (checked) and that the Alarm
Timeout is at least 5 seconds.
9. Click on the initial set-up page and draw a green line at the base of the door
jam. This will automatically set the proper regions of interest
10. The System should now be operating and ready for testing. (See testing the
System Pg. 43)
Summary of Contents for T-DAR T1000
