31
Image Decoding Timeout
Image Decoding Timeout specifies the maximum time the scanner will spend decoding an image. This parameter is
programmable in 1ms increments from 1ms to 3,000ms. The default timeout is 350ms.
@DETSET
Image Decoding Timeout
Set the image decoding timeout to 800ms:
1.
Scan the
Image Decoding Timeout
barcode.
2.
Scan the numeric barcodes
“8”, “0” and “0” from the “Digit Barcodes” section in Appendix.
3.
Scan the
Save
barcode from
the “Save/Cancel Barcodes” section in Appendix.
Read Barcode On/Off
Sending the Read Barcode Off command
~<SOH>0000#SCNENA0;<ETX>
to the scanner can disable it from reading
barcode, and the scanner is unable to scan barcode unless you send the Read Barcode On command
~<SOH>0000#SCNENA1;<ETX>
to it or power cycle it. By default, Read Barcode is On.
Summary of Contents for NLS-HR42
