Newland NLS-HR42, User Manual

Page: 42 / 265

28
Good Read Delay
Good Read Delay sets the minimum amount of time before the scanner can read another barcode. This parameter is
programmable in 1ms increments from 1ms to 3,600,000ms. The default setting is 500ms. Scan the appropriate barcode
below to enable or disable the delay.
@GRDENA1
Enable Good Read Delay
@GRDENA0
** Disable Good Read Delay
To set the good read delay, scan the barcode below, then set the delay (from 1 to 3,600,000ms) by scanning the digit
barcode(s) then scanning the Save barcode from the Appendix.
@GRDDUR
Good Read Delay
Set the good read delay to 1,000ms:
1. Scan the Good Read Delay barcode.
2.
Scan the numeric barcodes “1”, “0”, “0” and “0” from the “Digit Barcodes” section in Appendix.
3. Scan the Save
barcode from the “Save/Cancel Barcodes” section in Appendix.