** Enter Setup
Exit Setup
32
Command Trigger Mode
Command Trigger Mode:
The scanner activates a decode session when receiving the command string
of “
7E 01 30 30 30 30 40 53 43 4E 43 54 4D 31 3B 03
” (~<SOH>0000@SCNCTM1;<ETX>) or scanning
the
Start Trigger Simulation
barcode. The decode session continues until the barcode is decoded, or
the decode session timeout expires, or the scanner receives the command string of “
7E 01 30 30 30 30
40 53 43 4E 43 54 4D 30 3B 03
” (~<SOH>0000@SCNCTM0;<ETX>) or scans the
Stop Trigger
Simulation
barcode.
If the scanner receives the command string of “
7E 01 30 30 30 30 40 53 43 4E 43 54 4D 30 3B 03
”
(~<SOH>0000@SCNCTM0;<ETX>) or scans the
Stop Trigger Simulation
barcode during a decode
session, it will stop the decode session right away.
Command Trigger Mode
Start Trigger Simulation
Stop Trigger Simulation
Note: Command Trigger mode is available only when the scanner uses RS-232 or USB COM Port
Emulation. If you select this scan mode while using USB HID-KBW, USB HID-POS or IBM SurePOS
communication, the scanner will ignore this setting and automatically switch to the Blink mode.
Summary of Contents for HR11+ Aringa
