9
Power On/Off, Sleep, Reboot
Power on the scanner
Connect the scanner to a host device. Then the scanner will be turned on and automatically go into the
sleep mode.
Power off the scanner
There are four ways to turn off the scanner:
Remove the communication cable from the scanner; or
remove the communication cable from the host device; or
disconnect the power adaptor from mains; or
Scan the
Power Off
barcode from the “Operating Mode Options” section in Chapter 2.
Enter the sleep mode
If no operation is performed on the scanner for some time, the scanner will automatically enter the sleep
state.
Reboot the scanner
If the scanner stops responding to input or runs abnormally, turn off the scanner and then turn it back on.
Maintenance
1. The scan window should be kept clean.
2. Do not scratch the scan window.
3. Use soft brush to remove the stain from the scan window.
4. Use the soft cloth to clean the window, such as eyeglass cleaning cloth.
5. Do not spray any liquid on the scan window.
6. Do not use any detergent to clean other parts of the device except for water.
Note: The warranty DOES NOT cover damages caused by inappropriate care and maintenance.
Summary of Contents for HR11+ Aringa
