Chapter 6: Settings
Options Tab
158
NEO Hand-Held with Windows Mobile 6.1 Classic User Manual
initiates a normal scan sweep. If a value is assigned for the “Click Data” parameter, double-
clicking the scanner trigger inserts the “Click Data” value rather than initiating a scan.
Click Data
For both integrated and external scanners, this parameter determines which character is sent
to the application installed in your hand-held following a double-click. A dialog box ap-
pears, asking that you press the key you want to insert. The ASCII/Unicode key value of the
keypress is displayed.
6.31.2.2 Display Parameters
Scan Result
When this parameter is enabled, the type of bar code and the result of the scan appear on the
screen. Note that this information is only displayed after a successful decode and is visible
only while the scanner trigger is pressed. When the trigger is released, this information is
cleared from the screen.
Scan Indicator
When this parameter is enabled, the laser warning logo appears on the display whenever the
scanner is activated.
Scan Result Time (sec)
The value assigned to the “Scan Result Time (sec)” parameter determines how long the scan
results of a successful scan are displayed on the screen. Time is measured in seconds, and a
value of “0” (zero) disables the parameter. When you choose this option, a dialog box
appears where you can enter a value.
Good Scan Beep And Bad Scan Beep
These parameters determine whether or not the hand-held emits an audible scanner ‘beep’
when a good (successful) scan or a bad (unsuccessful) scan is performed. Set these parame-
ters to either
on
to enable the beeper or
off
to disable it.
Soft Scan Timeout
This parameter is used by the SDK “Scan” function (soft-scan: starting a scan session via the
SDK function, instead of a physical user trigger press). The value assigned to this parameter
determines the soft-scan timeout from 1 to 10 sec. (default is 3 sec.).
Note: To remove the scan result from the screen before the “Result Time” has expired, point
the scanner away from the bar code and press the trigger.
