Xen Topaz Programming Manual 10
Introduction to Programming
Before you Start Programming
shows Time & date with Extension number.
4. Re-start (HOT Start)
This mode may be selected in case of re-start (System Reset). The existing System Software
(stored to the Flash Memory) and the Customer data (stored to the RAM) will be remained.
♦
When the system requires to Re-Start (System Reset),
the operation is as follows;
1)
SW1
on the 308M unit will be set at the right side to “
H
” and turn System Power Switch to ON.
2) Wait until 1-2 minutes, LED2(RUN) is going to be lit
and
the Key Telephone’s display shows
Time & date with Extension number.
Before Programming
Before the programming, the Main Software Version and Port Number can be checked by the Dis-
play Key Telephone.
1. Confirmation of the Software Version
The Software Version can be checked by “
OPAC”
key and “
Dial
3”
(by On-Hook condition) or PRG90-
16-01.
2. Confirmation of the Port Number
The Own Port Number can be checked by Press “
CHECK”
key and “
CALL”
key (by On-Hook condi-
tion). The Other Port Number also can be checked by Press “
CHECK”
key and Dial Destination Exten-
sion Number (by On-Hook condition).
3. Concept of Slot Numbers
Slot Number will be fixed as followings and EXIFU Slots has no slot number.
4. Concept of Trunk/Extension Ports
The system decides the regulation of software port calculation as below;
- 308M/308E Unit = Up to 3 Trunk Ports and 8 Extension Ports
- 008E Unit = Up to 8 Extension Ports
5. Port Calculation for Trunk and/or Extension
In case the Trunk and/or Extension Interface Card (308M,308E or 008E) is Installed to a slot, the sys-
tem will automatically be detected the type of Interface card, then assign the Trunk port and/or Exten-
2 OPBOX
SLOT 6
SLOT 5
SLOT 4
SLOT 1(308M)
SLOT 2
SLOT 3
924M
Summary of Contents for Xen Topaz
